Friday, October 6, 2017

Week 7: Report Guidelines and Prototype

Dr. Du gave a 1 hour lecture about the final report guidelines. After, we headed back to Spartan Superway and discussed how to handle the swinging issue in our prototype design.

Over the weekend, Colin, Salvador, and I met at Salvador's house and used his workstation to rapid prototype our design. We used a drill press, popsicle sticks, and fasteners to simulate a linkage similar to our design. Below is a picture of our rapid prototype, which keeps the pod car leveled just like we assumed.



We will meet to further investigate the issues regarding the swinging motion found when using our design.
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Week 13: Writing the PID() Code for the Suspension Assembly
    This week, I was able to write the Arduino code for the suspension assembly, which utilizes the PID() function from Arduino. The Kp, Ki, and...
  • Week 3: Frame design
    Dr. Furman suggested that we should design a frame to showcase our suspension instead of transporting the entire half-scale track to Maker F...
  • Week 9: Spring Break Progress
    I was given advice by my ME106 lab instructor to use the PID() function from Arduino to account for the self-balancing logic in our main cod...